Vitocal 350-G Pro: DHW heated in compliance with hygiene standards

Vitocal 350-G Pro achieves high flow temperatures of up to 73°C, thus meeting the requirements of hygiene regulations for DHW heating.

The special temperature maintaining facility guarantees hot inlet temperatures downstream of the loading system at all times, even during the loading cycle.

 

The benefits at a glance:

  • High flow temperatures up to 73°C
  • Low noise and anti-vibration design
  • Modern cooling/heating function with buffer cylinder
  • Reliable technology and straightforward operation
  • Remote monitoring and communication available
  • Meets hygiene regulations for DHW heating
ID_commercial_heat-pumps_vitocal-350-G-Pro_content-image-1_L.png

Remote monitoring and communication

The control unit boasts numerous communication options, from a simple analogue modem to a LAN-supported system.

Use of Modbus technology and Bacnet is also possible. This makes the system accessible for remote maintenance over the internet, for example. It can also be integrated quickly into existing building management systems.

Efficient cooling

In cooling mode, the control unit decides whether the waste heat can be utilised for DHW heating and/or for charging the heating water buffer cylinder. If not, the waste heat is used to reheat the ground loop or is discharged to the outdoor air via a dry cooler.

ID_commercial_heat-pumps_vitocal-350-G-Pro_content-image-2_L.png
ID_commercial_heat-pumps_vitocal-350-G-Pro_content-image-3_L.png

Pre-assembled electrical equipment

The electrical equipment is already integrated inside the heat pump casing as standard. Factory-fitted contactors for fail-safe primary and secondary pumps, as well as protection for the compressor, guarantee straightforward installation and the safe and rapid integration of the large heat pump into the system.

Proven and reliable technology

The control philosophy was adopted from the Vitocal series for detached and two-family houses. Here too, the Refrigerant Cycle Diagnostic System (RCD) checks efficiency continuously and safeguards the efficient and reliable function at any operating point through the interaction between the electronic expansion valve (EEV) and the extensive sensor technology.

With the optional addition of a Vitocom 300 communication module, a comprehensive range of settings and system optimisations can be undertaken from anywhere via the internet or mobile phone.

ID_commercial_heat-pumps_vitocal-350-G-Pro_content-image-4_L.png
ID_commercial_heat-pumps_vitocal-350-G-Pro_content-image-5_L.png

Optimised appliance construction for quiet operation

As is the case for all heat pumps, the compressors emit noise in the 50 to 60 Hz range. Thanks to the high quality construction of the frame and anti-vibration casing components, it has been possible to keep this noise within the casing. Vibrations on the base support are barely perceptible as the 3-D antivibration construction is specifically designed to dissipate oscillations.


Vitocal 350-G Pro Specifications

Overview

Compressor type
Piston
Brine/water rated heating output
27.2 to 197 kW (B0/W35)
Water/water rated heating output
37.2 to 265.2 kW (W10/W35)
Rated heating output
27.2 to 197 kW
COP at B0/W35
up to 4.4
COP at W10/W35
up to 5.4
Sound power level
<65 dB(A)
Maximum flow temperature
73 °C
Refrigerant
R134a