Vitocal 262-A: Prepared at the factory for recirculation air mode
The Vitocal 262-A DHW heat pump is suitable for recirculation air mode, outdoor air mode, and recirculation air mode with air discharge to the outside.
For outdoor air mode or recirculation air mode with air discharge to the outside, the DHW heat pump is converted on site (accessories). This requires adaptation of the air intake aperture and/or air discharge aperture. The accessories for conversion offer a choice between a DN 160 and DN 180 outdoor air adaptor. The highest heat pump output values are achieved with the DN 180 outdoor air adaptor.
Type T2E:
- With dry immersion heater
- For outdoor air, recirculation air and extract air mode
- Cylinder capacity 298 l
Type T2H:
- With additional integral indirect coil for connecting an external heat generator for hybrid operation (immersion heater available as accessory)
- For outdoor air, recirculation air, and extract air mode
- Cylinder capacity 291 l
Type T2W:
- In conjunction with existing mono mode or dual mode DHW cylinder 160 to 500 l
- For wall mounting
- For outdoor air, recirculation air and extract air mode
Benefits at a glance:
Type T2E/T2H:
- DHW heat pump for recirculation air, outdoor air, or extract air mode, optionally with internal indirect coil for connecting an external heat generator (type T2H)
- Type T2H: Optimized hybrid operation with economical and ecological operation using intelligent control
- Very high output values in all operating modes
- Low noise emissions with special silent mode
- Straightforward commissioning due to pre-assembled and preset control unit, plus intuitive and easy operation
- DHW heated to a maximum temperature of 70 °C: Up to 65 °C via heat pump module and up to 70 °C with immersion heater or external heat generator
- Quick heat-up function with immersion heater (standard delivery with type T2E; accessory with type T2H)
- Smart grid compatible — two-stage utilization of power generated on site via heat pump and (switchable) immersion heater (type T2H: Accessory) for optimizing the use of power generated on site (required accessory: 3-phase energy meter)
- Consumption-dependent, automatic DHW
Type T2W:
- Heat pump for DHW heating in conjunction with separate mono mode or dual mode DHW cylinder
- For wall mounting
- For recirculation air, outdoor air, and extract air mode
- Very high output values in all operating modes
- Low noise emissions due to special silent mode
- Straightforward commissioning due to pre-assembled unit and preset control unit, plus intuitive and easy operation
- DHW heated to a maximum temperature of 70 °C (up to 65 °C via heat pump module and up to 70 °C with immersion heater or external heat generator)
- Quick heat-up function with immersion heater (accessories)
- Two-stage utilization by the heat pump of the power generated on site and (switchable) immersion heater (accessories) for optimizing the utilization of power generated on site (required accessory: 3-phase energy meter)

The Vitocal 262-A, type T2E is specially designed for DHW heating without additional external heat generators.
The Vitocal 262-A, type T2H is designed for DHW heating in conjunction with an external heat generator. Here, the heat pump is used for preheating and the external heat generator for reheating to the set DHW temperature. The heat pump control unit automatically controls the operating mode of both heat generators for maximum DHW convenience.
Vitocal 262-A, type T2W is designed for DHW heating in conjunction with an existing mono mode or dual mode DHW cylinder between 160 and 500 l.